You can then use the configure button below with the ip of your linksys to automatically configure your device.

Phone IP:  

If you are not able to configure using the "configure button above", please do the following :-

STEP 1
You must first determine what IP address your linksys device was assigned.  You need to pick up the phone attached to the Line 1 jack and dial:

                         **** (four asterisks)

then dial:     110 #

and you will be told the IP address of your device (e.g. 192.168.1.100)

STEP 2
Please go to any browser on your computer which is on your network and enter the address:

                   http://<IP ADDRESS>/

(where <IP ADDRESS> is replaced by the address that was given to you in STEP 1.

example by typing http://192.168.1.100 

STEP 3

Please login as admin in advance mode and find the provisioning tab. 

Please do the following :-

Provision Enable equal to Yes
Resync on Reset equal to Yes
Profile Rule equal to [--key $B]http://66.114.240.218/$A/$MA.cfg
GPP A equal to 10
GPP B equal to yourprofile

(you will need to know your "yourprofile" which will be given to you by support)

STEP 4

Save your settings and give at least 1 hour for our server to automatically reconfigure your device. All future changes including firmware updates will be done by our server.

For more info please visit our knowledgebase